The Place With No Name

HIKING HOME                FAMILY PAGES

Practice Glock grip reduction.  Experiment 2.

<BOW>

Since this is just a trash gun, I left the slide on and went to work with the dremel.  I took the back off the gun, and ground out the trigger guard notch a little bit.  It was aggravating my middle finger joint, and I just rounded it out a little to fit better.  Easy as pie.

A closer view.  You can see that I also buffed the right side for adhesion.

This is NOT what I expected when I started.  I essentially put the putty on the gun and went to squeezing it.  I did some shaping, and this is what it looks like.

Profile from the bottom.  Out of focus...  I have to figure out how to get this Nikon to take better close shots.

From the left.  With both hands supporting the gun, there is NO gap between either hand and the gun.  It's impossible to hold the gun wrong...  I will have to do some shaping when the putty dries.

Shane

 

 

 

 

 

 

 

 

COMMENTS, PROBLEMS, SUGGESTIONS, AND INSULTS SHOULD BE SENT TO


THIS WEBSITE, AND ALL CONTENT, IS PROTECTED BY COPYRIGHT.
PLEASE CLICK HERE FOR MORE INFORMATION.

This website is designed to be viewed at a resolution of 800 x 600, or higher, using Microsoft Internet Explorer.
Failure to use these settings may cause in inconsistent results.